Dry-Start Turboshaft Engine Trainer
RTSE-100A
Trainees can learn basic components and systems in a gas turbine engine with RTSE-100A Dry Start Turboshaft Engine training set. They can operate the engine starter with the KIOSK unit after learning on operational procedures. Training set includes all the systems that is on a gas turbine engine.
Features:
- Understanding fundamentals of aircraft Runnable Turboshaft Training Set and its components.
- Engine;
- 100% throttle, min 5500 RPM
- 24V-30V DC Starter motor included
- Oil tank on the engine included
- Oil cooler included
- Oil Pressure and Scavenge pumps included.
- Ignition system included
- 820-1230 BHP
- Four (4) Stage Axial LP Compressor
- Centrifugal Impeller HP Compressor
- Bleed Valve
- Nh turbine RPM is min 42400
- NI turbine RPM is min 35,000
- NPT turbine RPM is min 27,000
- Overall Pressure Ratio is 12:1
- At least 5 chip-detectors point – removed easily by hand
- Movable kiosk for the operating panel
- Oil drip pan
Components:
- Turboshaft Engine
- Starter
- Oil pump
- Igniter
- Fuel pump
- Oil Cooler
- Master power switch
- Start/Run switch
- Start button
- Cancel Button
- Pressure light indicator
- Power/start/running light
- Starter control switch and light
- İgnition control switch and light
- HP RPM indicator
- FPT RPM indicator
- EGT indicator
- Should have an original case
- The system mounted on a metal/aluminum mobile stand.
- Metal/aluminum frame with 4 wheels. 2 of 4 wheels are lockable.
- Training video for teachers
- Delivered fully assembled tested and ready to operate
- Colored Ultraviolet printing method on aluminum composite panel
Documentation:
-
Training video for teachers
-
Device’s original Manual
Required Items
- Fuel Kerosene
- Two 12 Volt Batteries
- Turbine Jet Oil
Optional Items
-
CBTS-100 Computer Based Training Software
-
GPU-100A Ground Power Unit