Runnable Turboshaft Engine Trainer

RTSE-100B

Trainees can learn basic components and systems in a gas turbine engine with RTSE-100B Runnable Turboshaft Engine training set. They can run the engine with the KIOSK unit after learning on operational procedures. Training set includes all the systems that is on a gas turbine engine.

RTSE-100A version is dry start only. The engine starter can be operated about 7 seconds then it stops. Whereas RTSE-100B version is runnable turboshaft engine. It can be run like normal gas turbine engine.

Features:

Understanding fundamentals of aircraft Runnable Turboshaft Training Set and its components.
Engine;
- 100% throttle, min 5500 RPM
- 24V-30V DC Starter motor included
- Oil tank on the engine included
- Oil cooler included
- Oil Pressure and Scavenge pumps included.
- Ignition system included
- 820-1230 BHP
- Four (4) Stage Axial LP Compressor
- Centrifugal Impeller HP Compressor
- Bleed Valve
- Nh turbine RPM is min 42400
- NI turbine RPM is min 35,000
- NPT turbine RPM is min 27,000
- Overall Pressure Ratio is 12:1
- At least 5 chip-detectors point – removed easily by hand
Fuel Tank included
Movable kiosk for the operating panel
Oil Drip Pan

Components:

Turboshaft Engine
- Starter
- Oil pump
- Igniter
- Fuel pump
- Oil Cooler
Master power switch
Start/Run switch
Start button
Cancel Button
Pressure light indicator
Power/start/running light
Starter control switch and light
İgnition control switch and light
HP RPM indicator
FPT RPM indicator
EGT indicator
Should have an original case

The system mounted on a metal/aluminum mobile stand.
Metal/aluminum frame with 4 wheels. 2 of 4 wheels are lockable.
Training video for teachers
Delivered fully assembled tested and ready to operate
Colored Ultraviolet printing method on aluminum composite panel

Documentation:

Training video for teachers
Device’s original Manual

Required Items

Fuel Kerosene
Two 12 Volt Batteries
Turbine Jet Oil

Optional Items

CBTS-100 Computer Based Training Software
GPU-100A Ground Power Unit