Heat Exchanger Experiment

TE-121

The training set main unit be able to meet the supply and measurement source needs of the modules connected to it. The following modules should be able to be connected to the training set. Tubular heat exchanger (TE 121.01), Plate heat exchanger (TE 121.02), Shell & Tube heat exchanger (TE 121.03) Agitated and coiled tank (TE 121.04). The training set has a resistance for hot water production.

The resistance PID in the training set is checked. There are 6 temperature measurements in the training set. The revolution speed of the mixer be able to be adjusted in the training set. There is a flow sensor on the training set to measure the water flow. The training set has a pump for circulating hot water.

Specifications

  1. The training set main unit be able to meet the supply and measurement source needs of the modules connected to it.
  2. The following modules should be able to be connected to the training set.
    • Tubular heat exchanger (TE 121.01),
    • Plate heat exchanger (TE 121.02),
    • Shell & Tube heat exchanger (TE 121.03)
    • Agitated and coiled tank (TE 121.04).
  3. The training set has a resistance for hot water production.
  4. The resistance PID in the training set is checked.
  5. There are 6 temperature measurements in the training set.
  6. The revolution speed of the mixer be able to be adjusted in the training set.
  7. There is a flow sensor on the training set to measure the water flow.
  8. The training set has a pump for circulating hot water.
  9. The cold-water supply of the training set made over the network.
  10. The trainer has a flow sensor for cold water.
  11. The pump to be used in the training set have the following features.
    • Power consumption: 120W
    • Maximum flow rate: 600L / h
    • Maximum head: 30m
    • Features of the heater:
    • Power consumption: 3kW
    • Temperature controller: 0… 70 ° C
    • Hot water tank: 10L
    • Measuring ranges
    • Temperature: 6x 0… 100 ° C
    • Flow rate: 2x 20… 250L / h
  12. Electrical requirements: 230V, 50Hz, 1 phase
  13. DAQ system will be available
  14. ADF software for data acquisition via Ethernet under Windows 8.1, 10
  15. The devices should be delivered fully assembled tested and ready to operate.

Experiments

  • Drawing temperature curves
  • Determination of the average heat transfer coefficient
  • Comparison of different heat exchanger types

Required for operation

  • PC with Windows recommended